Info:
Weight: 22.2g (around 40mg heavier than legit)
Length: 20.2cm (same as legit)
Aimed spinning style: Not defined
Creator: Magiai
Source: I made it
Additional info: The KT cap replica is the same length as the legit one. I have spun a menowa mod multiple times before making that mod, but I don't have one. It's around 80/90 percent similar spinning-wise.
Parts needed
- x2 Supertip Factory form barrel (Possible options: Monoprix eraser and Cora eraser)
- x4 OEM Sailor grip sub (only two can be used for a unicolor result) (Has multiple names)
- x2 Tinta Unita Supertip sub (Cap) (Can be found under many other names) (It is possible to use the barrels of this pen instead of a Supertip factory form barrel)
- x2 Conical weights (Mine are 5.12g)
- x1/2 Giotto Turbo Maxi barrels (possible to use only one, two for perfect symmetry)
- x1 Bic Round Stic (barrel)
- x8 O-rings (4 black and 4 transparent) (optional)
Additional Items
- Tape (various kinds)
Text tutorial
Preparation
- (If your tape-cutting skills are limited, or you have no sharp blade) Do diagonal cuts on both sides of white tape pieces. Four are required in total
- Cut the Giotto barrels into 2x 1.1cm pieces (Advised to cut from the backplug since the inner diameter of the barrel is larger at this side).
- Cut a 2.5cm piece of the Bic Round Stic barrel.
- Cut the upper rounded part of both of the Tinta Unita caps.
- Using a Dremel, scrape the inside of the Tinta Unita cap until the conical weight fits inside.
- On each of the black OEM grips, cut these blocks: 3 stripes, 6 stripes (with the last one being a large one), and 2 stripes (with one being a large one). Turn inside out each of these blocks except the 2-stripe one.
- On each of the colored OEM grips, cut these blocks: 1 large stripe, 2 stripes (With one being a large one), and 3 stripes. Turn inside out each of these blocks except the 2-stripe one.
- Cut the smallest part of the Supertip Front.
- Cut the Supertip-like barrel to 6.4cm (front part included).
- Cut a stripe from the leftover of an OEM grip.
Assembly
- Push the 1cm of the Giotto piece on the base of the Tinta Unita cap
- Wrap tape (black one here) on the Tinta unita cap until its outer diameter is equal to Emboss (/Kt cap flat part)
- Put the tape cut on the part of the Tinta unita cap next to the Giotto (this step can be done at the end)
- Put the grip in this order on the cap: 1 stripe (colored), 3 stripes (black), 3 stripes (colored). Leave some space for the last grip.
- Push the conical weight inside the cap (it should be snug enough for the assembly to be turned upside down without having the weight fall).
- Add two of the 2 stripes pieces on the tip (the black one is overgripped on the colored one). The first block is put with the big stripe first, and the second with the small stripe first.
- Put the last grip on the cap (it should cover the overgrip)
- Put a piece of a singular stripe of grip on the middle of the 2.5cm of the Bic round stic body. Repeat the cap process once and connect.
—————————————————————————————————————————————————
Mod Picture
