Info:
Weight: 18.33g
Length: 24.1cm
Aimed spinning style: Aesthetic
Creator: Magiai
Source: I made this mod.
Trivia: The name is a reference to the eponymous manga of Hirohiko Araki
Additional info: Superglue in this tutorial can be omitted if the Reynold 094 is replaced by Comssa instead (but be cautious as it can be too thick, and can break the cap if pushed too hard).
Parts needed
- x1 Nitomn Stalogy (Barrel)
- (Either BP or MP can be used)
- x2 Sailor IC Liquid Gel (2 grips)
- x1 Dong-a Anyball (1 grip)
- x2 Uni-ball Signo (2 tips)
- x2 Pentel HGG (2 tips)
- x1 Bic round stic (barrel)
- x1 OEM fake Signo DX (grip)
- x2 Tombow Color Twin (2 big caps)
- x1 Esquice gel (grip)
- x2 Reynold 094 (barrel)
- x2 Crayola Supertip (2 barrels)
- x1 PaperMate Supermagic+ (barrel)
- Can be subbed by Emboss
Text tutorial
Preparation
- Cut 2x ~1cm of Bic Round stic barrel (Has to be precised that the original length isn't precisely measured, but it's a bit under a centimeter).
- Cut 2x 0.7cm section of Esquice gel grips.
- Cut 2x 2cm section of SuperMagic+ barrel.
- Cut 2x 1 section of Anyball grip.
- Cut 2x 1.3cm section of Supertip barrel from the backplug side.
- Cut 2x 0.8cm of OEM Fake Signo DX grip.
- Empty both CT caps, and cut 0.5cm from the top of it.
- Empty the 094 barrel, and cut 2.7cm from the front (Including the tip part).
Assembly
- Brush some superglue on the tip of the 094 barrel, and connect it to the inside of the CT cap.
- Connect the remaining visible part of 094 to the 2cm of Supermagic+ by brushing some superglue on the remaining visible part of 094 barrel.
- Put a reversed HGG tip inside the Supermagic+ barrel, then put a Signo tip in the barrel (tip pointing outward)
- Put the Esquice Gel grip section inside the Supermagic+ barrel as far as possible to stabilise the tips.
- Add the grips on the cap package in this order: OEM fake Signo dx 0.5cm section, 1 section of Anyball grip, and a full section of Sailor grip (the Signo tip should end up being barely visible)
- Push the CT cap on the 1.3cm Supertip section, 1mm of Supertip should still be visible. (Caution: If you're not careful enough, this step could very well break the CT cap.)
- Put the ~1cm section of Bic Round Stic inside the BT barrel, and connect the cap (If necessary, brush a layer of superglue on the Bic Round Stic section to make it slightly wider).
- Repeat on the other side.
—————————————————————————————————————————————————
Mod Picture
