Info:
Weight:18g
Length: 20.6cm
Aimed spinning style: Aesthetic
Creator: An[!]mal
Source: FPSB V3 topic (obsolete)
Parts needed
- 1x G3 (barrel, grip and inktube)
- 1x Signo Broad (tip, grip and cap)
- 2x Hyperjell (cap and grip)
- 1x Sailor (grip)
- 1x Grip Matic (Barrel and tip)
- some grips
Additional Items
- Tape
- An insert
Text tutorial
Preparation
- Cut the clip of the Hyperjell cap.
- Cut 4 stripes off the G3 grip (You should have 4 stripes and one flat part with 2 stripes)
- Cut the front of the G3 barrel to the same length of the flat part with 2 stripes of G3 grip.
- Shave the nubs of the G3 cap.
- Cut the front of the Grip Matic barrel (the front part will be used)
- Cut 0.9 cm of a grip (specified as "some grips" in the list).
- Cut the Signo Broad cap where the "inner ring" is.
- Empty then cut a ~3cm section of G3 inktube. Wrap it in tape.
- Cut 2x 2 blocks of sailor grip, then 1x 5 blocks.
Assembly
Front side
- Connect the front of the G3 barrel with the front of the Grip Matic barrel using the G3 ink tube.
- Add the 9mm grip, then the Hyperjell grip on the G3 front structure.
- Screw the Grip Matic tip on the front.
- Overgrip the front part following this way: 2 stripes of Sailor
grip, the big section of signo broad cap, 2 stripes of sailor grip and 5
stripes of sailor grip.
Cap side
- Wrap your signo tip and grip with an insert, put it in the Hyperjell cap.
- Add tape on the G3 body then connect it to the Hyperjell cap.
